|
|
|
Stronger
and Safer Than Nails — The ONLY glue-on horseshoe with a built-in SHOCK
ABSORBER |
|
|
Sigafoos Series I™
Application Instructions
Preparing Hoof | Preparing Shoe | Applying Shoe | Removing Shoes | Notes
Preparing the hoof
The hoof is prepared for bonding in much the same way it would be for reconstruction or re-shoeing.
1. Remove any excess dirt from the hoof using a wire brush.
2. Sand the walls of the hoof lightly using a sanding block, disk sander or a Dremel tool.
3. Place legs in the supplied poly sleeves to protect the skin from adhesives and solvents (see note on the use of leg sleeves).
4. If this is the first application of the Series I shoe, clean the wall thoroughly with acetone.
|
|
|
Sanding Block |
Grinder |
Poly Sleeve onto Leg |
Note on the use of poly leg sleeves: The leg sleeves help to protect the leg from the solvents and adhesives used during hoof reconstruction and/or the application of the Sigafoos Series™ adhesive-bonded shoes. To use these sleeves, turn them inside out so that the yellow tape liner is on the inside of the sleeve. Place the foot into the sleeve so the taped end is at the coronet. Remove the yellow liner to expose the adhesive and stick the tape to the coronet to help seal the sleeve. It is helpful to run some additional tape (adhesive or duct tape) around the coronet over the top of the sleeves.
Preparing Hoof | Preparing Shoe | Applying Shoe | Removing Shoes | Notes
Products Application Instructions Technical Articles Features & Benefits How to Order Home
What do you think of our site?
Copyright © 1999-2008 Sound Horse Technologies, Inc.
PO Box 689 • Unionville, PA 19375
Phone: 800-801-2654 • Phone: 610-347-0453 •
Fax: 610-347-1822
horseshoes@soundhorse.com